Vehicle Standard (Australian Design Rule – Definitions and Vehicle Categories) 2005 Amendment 3 (Cth)

Vehicle Standard (Australian Design Rule – Definitions and Vehicle Categories) 2005 Amendment 3

I, JAMES ERIC LLOYD, Minister for Local Government, Territories and Roads, determine this vehicle standard under subsection 7 (1) of the Motor Vehicle Standards Act 1989.

Dated               12^th Sept   2007

[Signed]

James Eric Lloyd

Minister for Local Government, Territories and Roads

CONTENTS

1. LEGISLATIVE PROVISIONS............................................................................ 3

1. AMENDMENT OF VEHICLE STANDARD...................................................... 3

SCHEDULE 1.................................................................................................................... 4

1. LEGISLATIVE PROVISIONS

1.1.Name of Legislative Instrument

1.1.1.This instrument is the Vehicle Standard (Australian Design Rule – Definitions and Vehicle Categories) 2005 Amendment 3.

1.1.2.This instrument may also be cited as Australian Design Rule — Definitions and Vehicle Categories Amendment 3.

1.2.Commencement

1.2.1.This instrument commences on the day after it is registered.

1. AMENDMENT OF VEHICLE STANDARD

2.1.The changes specified in Schedule 1 amend Vehicle Standard (Australian Design Rule – Definitions and Vehicle Categories) 2005.

SCHEDULE 1

1. Add the following, in alphabetical order, to 3.  DEFINITIONS

TWINNED WHEELS - means two wheels mounted on the same axle, the distance between centres of their areas of contact with the ground being less than 460 mm.  Twinned wheels shall be considered as one wheel.