Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006 Amendment 1 (Cth)

Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006

Amendment 1

I, JAMES ERIC LLOYD, Minister for Local Government, Territories and Roads, determine this vehicle standard under subsection 7 (1) of the Motor Vehicle Standards Act 1989.

Dated               5^th October 2007

[SIGNED]

James Eric Lloyd

Minister for Local Government, Territories and Roads

CONTENTS

1.           LEGISLATIVE PROVISIONS

2.           AMENDMENT OF VEHICLE STANDARD

SCHEDULE 1

1.   LEGISLATIVE PROVISIONS

1.1.Name of Legislative Instrument

1.1.1.               This Instrument is the Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006 Amendment 1.

1.2.Commencement

1.2.1.               This Instrument commences on the day after it is registered.

1. AMENDMENT OF VEHICLE STANDARD

1. 1                   The changes specified in Schedule 1 amend Vehicle Standard (Australian Design Rule 43/04 – Vehicle Configuration and Dimensions) 2006

SCHEDULE 1

[1]                   Replace Clause “6.4.1 for any point in the width of the vehicle which is within one metre fore and aft of any ‘Axle’, 100 mm;” with;

“6.4.1             [This clause has been deleted]”

[2]                   Add Clause

“6.6                 The ‘Running Clearance’ of a vehicle, other than an L-Group vehicle must be not less than 100 mm.”