Tariff Concession Revocation Order 23/2010 Tariff Concession Order 0939948 (Cth)

TARIFF CONCESSION REVOCATION ORDER

Under Section 269SC(4) of the Customs Act 1901, I James Buntine a delegate of the Chief Executive Officer

(a) revoke Tariff Concession Order Number 0802667 made on 04.07.08, in respect of the goods described in TABLE A below.  This Revocation has effect from 07.09.09; and

(b) make in its place the Tariff Concession Orders described in TABLE B. The goods specified in Column 1 of TABLE B are goods to which the item in Part III of Schedule 4 to the Customs Tariff Act 1995 specified in Column 2 of TABLE B applies. The Order shall have effect from the date notified in paragraph (a) above as the date of effect for the Revocation.

TABLE A

               COLUMN 1

Description of Goods including the
Customs Tariff Classification

COLUMN 2

Schedule 4 Item Number Last date of effect

8419.50.90 HEAT EXCHANGERS, PLATE-DISMANTLE, having ALL of the following:
  (a) frames:
         (i) length NOT less than 300 mm;
        (ii) height NOT less than 750 mm;
       (iii) thickness NOT less than 20 mm
  (b) plates:
        (i) surface NOT less than 1 300 cm2;
       (ii) thickness NOT less than 0.5 mm
  (c) working pressure NOT less than 10 bar;
  (d) maximum working temperature NOT less than 110 degrees C

Op. 08.04.08   - TC 0802667 50
06.09.09

This is page 1 of 2 Pages of the instrument.

   ..James Buntine........................

Dated 28 October 2009   Delegate of the Chief Executive Officer

TABLE B

               COLUMN 1

Description of Goods including the
Customs Tariff Classification

COLUMN 2

Schedule 4 Item Number Last date of effect

8419.50.90 HEAT EXCHANGERS, PLATE-DISMANTLE, but not including air to air
heat exchangers, having ALL of the following:
  (a) frames, having ALL of the following:
         (i) length NOT less than 300 mm;
        (ii) height NOT less than 750 mm;
       (iii) thickness NOT less than 20 mm,
  (b) plates, having BOTH of the following:
        (i) surface NOT less than 1 300 cm2;
       (ii) thickness NOT less than 0.5 mm,
  (c) working pressure NOT less than 10 bar;
  (d) maximum working temperature NOT less than 110 degrees C

Op. 07.09.09   - TC 0939948 50

This is page 2 of 2 Pages of the instrument.

   ..James Buntine........................

Dated 28 October 2009   Delegate of the Chief Executive Officer