Road Safety (Vehicles) Amendment (Heavy Vehicle National Law) Regulations 2014 (Vic)
Road Safety (Vehicles) Amendment (Heavy Vehicle National Law) Regulations 2014
S.R. No. 23/2014
TABLE OF PROVISIONS
Regulation Page
1Objective
2Authorising provision
3Definitions
4Installation of operations plates and the modification of vehicles
5Grounds for suspension
6Non-application to heavy vehicles
7Schedule 2 Vehicle Standards
═══════════════
ENDNOTES
STATUTORY RULES 2014
S.R. No. 23/2014
Road Safety Act 1986
Road Safety (Vehicles) Amendment (Heavy Vehicle National Law) Regulations 2014
The Governor in Council makes the following Regulations:
Dated: 29 April 2014
Responsible Minister:
TERRY MULDER
Minister for RoadsYVETTE CARISBROOKE
Clerk of the Executive Council
1Objective
The objective of these Regulations is to make minor amendments to the Road Safety (Vehicles) Regulations 2009 to give effect to the Heavy Vehicle National Law (Victoria).
2Authorising provision
These Regulations are made under section 95 of the Road Safety Act 1986.
3Definitions
In regulation 5 of the Road Safety (Vehicles) Regulations 2009[1] insert the following definition—
"NHVR Code of Practice for the Approval of Heavy Vehicle Modifications means the NHVR Code of Practice for the Approval of Heavy Vehicle Modifications as published from time to time by the National Heavy Vehicle Regulator within the meaning of the Heavy Vehicle National Law (Victoria).".
4Installation of operations plates and the modification of vehicles
In regulation 21(3)(b) of the Road Safety (Vehicles) Regulations 2009, for "the National Code of Practice for Heavy Vehicle Modification published by the Department of Infrastructure and Transport as Vehicle Standards Bulletin No. 6" substitute "the NHVR Code of Practice for the Approval of Heavy Vehicle Modifications".
5Grounds for suspension
In regulation 114(c) of the Road Safety (Vehicles) Regulations 2009, for "under the Act or these Regulations" substitute "under the Act, these Regulations or the Heavy Vehicle National Law (Victoria)".
6Non-application to heavy vehicles
In regulation 244A of the Road Safety (Vehicles) Regulations 2009, after "245," insert "245A,".
7Schedule 2 Vehicle Standards
In the note after the heading to Part 3 of Schedule 2 to the Road Safety (Vehicles) Regulations 2009, after "For guidance on vehicle modifications see" insert "NHVR Code of Practice for the Approval of Heavy Vehicle Modifications—".
═══════════════
ENDNOTES
[1] Reg. 3: S.R. No. 118/2009. Reprint No. 1 as at 1 August 2013. Reprinted to S.R. No. 87/2013. Subsequently amended by S.R. No. 133/2013, 153/2013 and 176/2013.
——
Table of Applied, Adopted or Incorporated Matter
The following table of applied, adopted or incorporated matter is included in accordance with the requirements of regulation 5 of the Subordinate Legislation Regulations 2004.
| Statutory rule provision | Title of applied, adopted or incorporated document | Matter in applied, adopted or incorporated document |
| Regulation 3 which inserts the definition of NHVR Code of Practice for the Approval of Heavy Vehicle Modifications in regulation 5 of the Road Safety (Vehicles) Regulations 2009 | NHVR Code of Practice for the Approval of Heavy Vehicle Modifications published by the National Heavy Vehicle Regulator in February 2014 | The whole |
| Regulation 4 which amends regulation 21(3)(b) of the Road Safety (Vehicles) Regulations 2009 | NHVR Code of Practice for the Approval of Heavy Vehicle Modifications published by the National Heavy Vehicle Regulator in February 2014 | The whole |
| Regulation 7 which amends the note to Part 3 of Schedule 2 to the Road Safety (Vehicles) Regulations 2009 | NHVR Code of Practice for the Approval of Heavy Vehicle Modifications published by the National Heavy Vehicle Regulator in February 2014 | The whole |
0
0
0