Prescribed Goods (General) Amendment Orders 2004 (No. 4) (Cth)

Prescribed Goods (General) Amendment Orders 2004 (No. 4)

I, WARREN ERROL TRUSS, Minister for Agriculture, Fisheries and Forestry, make these Orders under regulation 3 of the Export Control (Orders) Regulations 1982.

Dated 25 November 2004

WARREN TRUSS

Minister for Agriculture, Fisheries and Forestry

1. Name of Orders

These Orders are the Prescribed Goods (General) Amendment Orders 2004 (No. 4).

1. Commencement

These Orders commence on 1 December 2004.

1. Amendment of Prescribed Goods (General) Orders 1985

Schedule 1 amends the Prescribed Goods (General) Orders 1985.

Schedule 1          Amendments

(section 3)

[1]          Order 87

substitute

1. Declaration of official marks

For the purposes of the definition of official mark in section 3 of the Act, each of the following is declared to be an official mark:

(a)a mark of the design set out in Schedule 1;

(b)a stamp that applies that mark;

(c)a mark of the design set out in Schedule 2;

(d)a stamp that applies that mark

(e)a mark of the design set out in Schedule 3;

(f)a stamp that applies that mark;

(g)a mark of the design set out in Schedule 4;

(h)a stamp that applies that mark;

(i)a mark of the design set out in Schedule 5;

(j)a stamp that applies that mark;

(k)a mark of the design set out in Schedule 6;

(l)a stamp that applies that mark;

(m)a seal of the design set out in Schedule 7;

(n)a seal of the design set out in Schedule 8;

(o)a seal of the design set out in Schedule 9;

(p)a seal of the design set out in Schedule 10;

(q)a mark of the design set out in Schedule 11;

(r)a stamp that applies that mark;

(s)a mark of the design set out in Schedule 12;

(t)a stamp that applies that mark;

(u)a mark of the design set out in Schedule 12A;

(v)a stamp that applies that mark.

[2]          After Schedule 12

insert

Schedule 12A    Official mark specified in paragraph 87 (u)

(paragraph 87 (u))

1. Design of mark

Subject to clauses 2 and 3, the design of the official mark referred to in paragraph 87 (u) is as follows (with XXXX replaced by a number identifying the office to which the stamp that applied the mark was allocated):

1. Size of mark

The dimensions of the mark are to be as follows:

(a)inner width, 37 mm;

(b)outer width, 38 mm.

1. Lettering in mark

The letters are to be in 9 point Helvetica Bold.