Airworthiness Directives 2004 - Revocation and Remaking - Bombardier (Canadair) CL-600 (Challenger) Series Aeroplanes (Cth)

Airworthiness Directives 2004

I, DAVID ALAN VILLIERS, delegate of the Civil Aviation Safety

Authority, acting under subregulation 39.001 (1) of the Civil

Aviation Safety Regulations 1998:

(a)       revoke the Airworthiness Directives mentioned in

Schedule 1; and

(b)       make, as separate instruments, each Airworthiness

Directive mentioned in Schedule 1 and attached.

David Villiers

Delegate of the Civil Aviation Safety Authority

 20 December 2004

Note:   Each attached Airworthiness Directive is being re-made in exactly the

same form as appears in the latest published edition of the Directive.

Schedule 1             Revocation and Remaking of

Airworthiness Directives

Bombardier (Canadair) CL-600 (Challenger) Series Aeroplanes

AD Name  AD Number

Windshield and Side Windows Reinforcing T Plates - CANCELLED                   AD/CL-600/1

Elevator Inboard Hinge Fitting - Inspection and Replacement  AD/CL-600/2

Passenger Door Interior and Exterior Handles and Latch Mechanism -              AD/CL-600/3

Auxiliary Power Unit Load Control Valve - Special Check and Adjustment       AD/CL-600/4

Main Landing Gear Brake Assemblies - Inspection and Re-Identification            AD/CL-600/5

Branson Fuel Tank - Electrical Harness - Inspection and Modification               AD/CL-600/6

Horizontal Stabiliser Pitch Trim Actuator - Modification  AD/CL-600/7

Landing Gear Electrical Harnesses - Modification  AD/CL-600/8

Junction Box No.2 - Vertical Navigation and Glide Slope Relay - Modification  AD/CL-600/9

Autopilot Duplex Servo - Installation of Protective Cover  AD/CL-600/10

Stick Pusher - Inspection and Modification  AD/CL-600/11

Throttle Quadrant Wear Strips - Special Check and Modification - CANCELLED          AD/CL-600/12

Brake Control Push-Pull Cable  AD/CL-600/13 Amdt 1

Engine Pylon Fuel Feed Tube Assembly - Modification  AD/CL-600/14

Aileron and Elevator Flutter Dampers  AD/CL-600/15 Amdt 1

Wing Outboard Flap Vane and Structure - CANCELLED  AD/CL-600/16 Amdt 1

Flight Controls - Elevator Cable Inspection  AD/CL-600/17

Introduction of Earthing Point  AD/CL-600/18

Fire Extinguishing Bottle Squib Wiring  AD/CL-600/19

ADG Output Harness Chafing  AD/CL-600/20

Tail Cone Fuel Tank  AD/CL-600/21 Amdt 2

Engine Fire Detection, Indication and Extinguishing Systems  AD/CL-600/22

Brakes  AD/CL-600/23 Amdt 1

Generator and APU Feeder Wires  AD/CL-600/24

Throttle Quadrant  AD/CL-600/25 Amdt 1

Flap Actuators  AD/CL-600/26

Rudder Control Quadrant  AD/CL-600/27 Amdt 1

Sunstrand Air Driven Generator  AD/CL-600/28

Horizontal Stabiliser Trim Actuator  AD/CL-600/29

Time Limits and Maintenance Checks  AD/CL-600/30

Fuel Tank Arcing Prevention  AD/CL-600/31

Underfloor Pressure Bulkhead at FS409.00  AD/CL-600/32 Amdt 2

Overwing Emergency Exit Hatches  AD/CL-600/33

Flap Operation  AD/CL-600/34 Amdt 2

Main Landing Gear Main Fitting  AD/CL-600/35 Amdt 1

Elevator Flutter Damper Shear Pins  AD/CL-600/36

Flight Spoiler Centre Hinge Fitting  AD/CL-600/37 Amdt 1

IDG Cables and Firewall Separator  AD/CL-600/38 Amdt 1

Fuel Level Sensing Wiring Chafing  AD/CL-600/39

Electrical Power - Chafing of IDG Cables  AD/CL-600/40

Fire Warning Control Unit  AD/CL-600/41

Lower Wing Plank  AD/CL-600/42

Cargo Compartment Smoke Detector  AD/CL-600/43

Power Transfer Contactors  AD/CL-600/44

Engine Support Beam  AD/CL-600/45

Main Windshield Fasteners  AD/CL-600/46

Center Tank Fuel Transfer Shutoff Valve  AD/CL-600/47

CVR/FDR Paint Stripping  AD/CL-600/48

Angle of Attack Transducer  AD/CL-600/49

Main Fuel Tank Vent System Modification  AD/CL-600/50

Chafed IDG Cables  AD/CL-600/51

Refuel Floodlight  AD/CL-600/52

Fuel Migration and Centre of Gravity Limit  AD/CL-600/53

CL-600-2B19 RJ Overwing Exit Placards  AD/CL-600/54

Flap Vane System  AD/CL-600/55

APU Cooling Air Exhaust  AD/CL-600/56

Horizontal Stabilizer Trim Actuator  AD/CL-600/57

Aileron Stiffness  AD/CL-600/58

IDG Cables  AD/CL-600/59

Flap Vane Brackets  AD/CL-600/60

Main Landing Gear Side-Brace  Fitting Shaft  AD/CL-600/61