AD/B737/276 Nacelle Support Fitting Attachment Fasteners (Cth)
AIRWORTHINESS DIRECTIVE
For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.001(1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.
Boeing 737 Series Aeroplanes
| AD/B737/276 | Nacelle Support Fitting Attachment Fasteners | 2/2006 |
Applicability: | Model 737-600, -700, -700C, and -800 series aircraft, line numbers 1 through 761; except for line numbers 596, 683, 742, 749, 750, 751, 754, 755, 759, and 760. |
Requirement: | Action in accordance with the technical requirements of FAA AD 2005-24-03 Note: Boeing Service Bulletin 737-57-1275 Revision 1, or later FAA approved revision, refers. |
Compliance: | As specified in the Requirement document, with a revised effective date of |
| This Airworthiness Directive becomes effective on 16 February 2006. | |
Background: | The FAA received a report from the manufacturer that in production, during the installation of certain attachment fasteners for the nacelle support fittings, only one washer was installed instead of two. Inadequate fastener clamp-up could result in cracking of the fastener holes, cracking along the lower wing skin panels, fuel leaking from the wing fuel tanks onto the engines, and possible fire. |
David Villiers
Delegate of the Civil Aviation Safety Authority
22 December 2005
0
0
0