Telecommunications Technical Standard (CDMA Customer Equipment — AS/ACIF S042) Amendment 2003 (No. 1)
The AUSTRALIAN COMMUNICATIONS AUTHORITY makes this Technical Standard under subsection 376 (1) of the Telecommunications Act 1997.
Dated 12 November 2003 R HORTON Chair A HORSLEY Deputy Chair
Australian Communications Authority
1 Name of Technical Standard
This Technical Standard is the Telecommunications Technical Standard (CDMA Customer Equipment — AS/ACIF S042) Amendment 2003 (No. 1).
2 Commencement
This Technical Standard commences on gazettal.
3 Amendment of Telecommunications Technical Standard (CDMA Customer Equipment — AS/ACIF S042) 1999
Schedule 1 amends the Telecommunications Technical Standard (CDMA Customer Equipment — AS/ACIF S042) 1999.
Schedule 1 Amendments
(section 3)
[1] Subsection 1 (2), at the foot
insert
Note 1 The alternate citation mentioned in subsection (2) is the name by which the AS/ACIF Standard, adopted by this Technical Standard under section 6, is usually cited. The AS/ACIF Standard was published in 1999.
Note 2 The AS/ACIF Standard, as adopted by this Technical Standard, does not include any amendments made by Standards Australia and the Australian Communications Industry Forum after the commencement of this Technical Standard. If amendments are made, the terms of this Technical Standard will differ from those of the AS/ACIF Standard unless the AS/ACIF amendments are adopted by the ACA.
[2] Section 4, after definition of Act
insert
AS/ACIF Standard means:
(a) the Australian Standard/Australian Communications Industry Forum Standard: Requirements for connection to an air interface of a telecommunications network — Part 1: General (AS/ACIF S042.1:1999); and
(b) the Australian Standard/Australian Communications Industry Forum Standard: Requirements for connection to an air interface of a telecommunications network — Part 2: CDMA (IS-95) (AS/ACIF S042.2:1999);
published in December 1999 by the Australian Communications Industry Forum and Standards Australia International Limited.
[3] Sections 5 and 6
substitute
5 Application of Technical Standard
This Technical Standard applies to CDMA customer equipment.
6 Standard for customer equipment
The customer equipment to which this Technical Standard applies must comply with the AS/ACIF Standard.
7 Transitional
(1) This section applies to CDMA customer equipment of a type that, before the commencement of this Technical Standard:
(a) was available in Australia for use, or was being manufactured or imported; and
(b) complied with Telecommunications Technical Standard (CDMA Customer Equipment — ACA TS 200–1998).
(2) The CDMA customer equipment is taken to comply with this Technical Standard.