Tasmania Class 3 Pig Trailer Dimension Exemption Notice 2024 (No.1)

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au C2024G00109 In force Gazette

Legislation content

HEAVY VEHICLE NATIONAL LAW

Tasmania Class 3 Pig Trailer Dimension Exemption Notice 2024 (No.1)

  1. Purpose

 

This Notice grants exemptions from mass and dimension requirements for a class 3 heavy vehicle that includes a pig trailer carrying a specified item such as a light aircraft, yacht, rowing boat or surfboat.

 

2.       Authorising provision

 

1)      This Notice is made under the following provision of the Heavy Vehicle National Law (HVNL):

 

a)      section 117 – Regulator’s power to exempt category of class 1 or 3 heavy vehicles from compliance with mass or dimension requirement.

 

3.       Title

 

This exemption Notice may be cited as the Tasmania Class 3 Pig Trailer Dimension Exemption Notice 2024 (No.1).

 

4.       Commencement date

 

This Notice commences on 10 February 2024.

 

5.       Expiry date

 

This Notice expires on 9 February 2029.

 


6.       Definitions

 

1)      Unless otherwise stated, words and expressions used in this notice have the same meanings as those in the HVNL and its regulations.

 

2)      In this Notice:

Specified loads means a load that is:

a)      an aircraft,

b)      a watercraft, and

c)       any other components or equipment associated with those items.

 

Guide means the Tasmania Class 3 Pig Trailer Dimension Exemption Operators Guide published by the National Heavy Vehicle Regulator, as amendment from time to time.

 

7.       Application

 

1)      This exemption notice applies to a class 3 heavy vehicle that meets all the requirements in this section.

 

2)      This exemption notice applies to a heavy combination consisting of:

 

a)      a truck; and

b)      a pig trailer that is carrying a specified item.

 

3)      This Notice applies in Tasmania.

 

4)      A heavy vehicle to which this section applies and that complies with the conditions of this notice is an eligible vehicle.

 

8.       Exemption – Prescribed dimension requirements

 

1)      An eligible vehicle is exempt from the following dimension requirements under Schedule 6 of the Heavy Vehicle (Mass Dimension and Loading) National Regulation (MDL Regulation):

 

a)      section 3 – Length (combination or single vehicle)

b)      section 5 – Length (rear overhang)

 

2)      An exemption in 1) only applies to the extent that specific conditional dimension limits are provided in section 9.

 


9.       Condition – Dimension limits

 

1)      For a parameter given in column 1 of Table 3, an eligible vehicle must not exceed the dimension given in column 2.

 

Table 1: Maximum dimensions

Column 1

Column 2

Parameter

Maximum Dimension (m)

Length (combination or single vehicle)

25.0

Length (rear overhang)

5.0

 

2)      For this section, the width of a heavy vehicle must be measured in the same manner as in section 8 of the Heavy Vehicle (Vehicle Standards) National Regulation.

 

10.   Condition – Multiple specified loads

 

More than one specified load may be carried so long as the carriage of multiple specified loads does not cause another regulatory dimension to be exceeded.

 

11.   Condition - General operating conditions

 

 If a load on an eligible vehicle can be safely loaded in more than one way, it must be loaded in a way that minimises the dimensions of the vehicle.

 

12.   Condition - Pilot vehicle requirements

 

Where a Specified Road Manager Network Requirement in the Guide requires an eligible vehicle to be accompanied by a pilot vehicle, the pilot vehicle must comply with the requirements set out within the Tasmanian Class 1 Heavy Vehicle Pilot and Escort Guidelines.

 

Note: The Tasmanian Class 1 Heavy Vehicle Pilot and Escort Guidelines are maintained and published by the Tasmanian Department of State Growth.

 

13.   Application of Schedule 8 of the MDL Regulation

 

1)      The following conditions in Schedule 8 of the MDL Regulation are applied to eligible vehicles as though they are class 1 vehicles.

 

a)      section 2, Warning signs and flags

b)      section 5, Side and rear markers and warning lights for oversize vehicles used at night

c)       section 6, Headlights

d)      section 8, No travelling if low visibility

e)      section 9, Minimum following distance

f)        section 10 Allowing overtaking

 

 

14.   Condition – Stated areas or routes

 

1)      An eligible vehicle complying with the conditions of this notice has general access in Tasmania.

 

2)      For the purposes of section 119(1)(a) of the HVNL, an area or route specified in this section is a stated area or route to which this notice applies.

 

3)      In this section general access means access to all roads except as restricted by the Specified Road Manager Network Requirements in the Guide.

 

Peter Austin

Director, Policy Implementation

National Heavy Vehicle Regulator

 

 

Overview

The Tasmania Class 3 Pig Trailer Dimension Exemption Notice 2024 (No.1) was enacted to address the specific needs of transporting specified loads such as light aircraft, yachts, rowing boats, and surfboats using class 3 heavy vehicles with pig trailers in Tasmania. This Notice was made under section 117 of the Heavy Vehicle National Law (HVNL), granting exemptions from mass and dimension requirements for these vehicles, provided certain conditions are met. The policy objective is to facilitate the safe and efficient transportation of these specified loads while maintaining road safety standards, as articulated in the Notice. This exemption notice, which commenced on 10 February 2024 and will expire on 9 February 2029, applies exclusively within Tasmania and outlines specific dimensional limits and conditions that must be adhered to by operators of eligible vehicles. The Notice mandates that eligible vehicles comply with particular dimension limits and general operating conditions, including the requirement to minimise vehicle dimensions when possible, and mandates the use of pilot vehicles where specified. Furthermore, certain conditions from Schedule 8 of the Heavy Vehicle (Mass Dimension and Loading) National Regulation are applied to eligible vehicles as though they are class 1 vehicles, ensuring consistent safety standards are upheld. The Notice provides for general access across Tasmania, subject to any restrictions outlined in the Tasmania Class 3 Pig Trailer Dimension Exemption Operators Guide published by the National Heavy Vehicle Regulator.

Scope and Application

The Tasmania Class 3 Pig Trailer Dimension Exemption Notice 2024 (No. 1) provides exemptions from certain mass and dimension requirements for class 3 heavy vehicles in Tasmania, specifically those that include a pig trailer carrying specified items such as light aircraft, yachts, rowing boats, or surfboats. This exemption notice applies to heavy vehicle combinations consisting of a truck and a pig trailer carrying such specified loads, and it operates within the jurisdiction of Tasmania. The Notice grants exemptions from certain dimension requirements under Schedule 6 of the Heavy Vehicle (Mass Dimension and Loading) National Regulation, such as length and rear overhang, provided that the vehicle complies with the specified dimensional limits and conditions outlined in the Notice. Additionally, it requires compliance with certain general operating conditions and pilot vehicle requirements when applicable. The Notice also applies specific conditions from Schedule 8 of the MDL Regulation to eligible vehicles as though they are class 1 vehicles. This Notice, made under section 117 of the Heavy Vehicle National Law, commences on 10 February 2024 and expires on 9 February 2029, unless otherwise amended.

Key Provisions

The Tasmania Class 3 Pig Trailer Dimension Exemption Notice 2024 (No.1) is made under section 117 of the Heavy Vehicle National Law (HVNL), which grants the Regulator’s power to exempt certain categories of vehicles from compliance with mass or dimension requirements. This Notice allows for exemptions from mass and dimension requirements specifically for a class 3 heavy vehicle that includes a pig trailer carrying specified items such as a light aircraft, yacht, rowing boat, or surfboat. It commences on 10 February 2024 and will expire on 9 February 2029. The Notice applies to vehicles in Tasmania that meet the defined criteria, including those that comply with the conditions outlined in the Notice, which are considered eligible vehicles. The Notice imposes specific obligations and requirements on the parties it governs. An eligible vehicle, as defined, is exempt from certain dimension requirements under Schedule 6 of the Heavy Vehicle (Mass Dimension and Loading) National Regulation (MDL Regulation). Specifically, this includes exemptions from length requirements for both combination and single vehicles as well as rear overhang length. However, these exemptions apply only to the extent that the vehicle adheres to the conditional dimension limits provided in section 9 of the Notice. The Notice also specifies that for certain parameters, such as length and rear overhang, the vehicle must not exceed the maximum dimensions provided in Table 3 of the Notice. Additionally, the width of the vehicle must be measured according to the guidelines in section 8 of the Heavy Vehicle (Vehicle Standards) National Regulation. For any breach of the conditions set forth in the Notice, there may be significant legal consequences. The Notice does not explicitly detail penalties or specific consequences for non-compliance; however, breaches of the HVNL and its regulations generally can lead to both civil and criminal penalties. Civil penalties may include fines, while criminal penalties could involve imprisonment. The exact penalties would depend on the specific breach and the applicable provisions of the HVNL and related regulations. Operators must ensure strict adherence to the Notice to avoid any potential legal repercussions.

Legal classification tags

Area of Law
Commercial Law
Instrument
Gazette Notice
Concepts
Definitions & Interpretation
Commencement Provisions
Regulatory Standards
Reporting & Disclosure Obligations

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.