Heavy Vehicle National Law - Victoria Class 3 Livestock Carrier Mass and Dimension Exemption Notice 2019 (No.1)

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au C2019G00080 In force Gazette

Legislation content

HEAVY VEHICLE NATIONAL LAW

Victoria Class 3 Livestock Carrier Mass and Dimension Exemption Notice 2019 (No.1)

  1. Purpose

 

This Notice provides mass and dimension exemptions that support the Victorian livestock loading scheme. This Notice is intended to work with the Information Bulletin for the Livestock Transport (Victoria) issued by VicRoads, and compliance with the rules in that Bulletin is a condition of this Notice.

 

Note:  This notice works with the Information Bulletin for the Livestock Transport (Victoria) issued in August 2013 by VicRoads 

Certain references in the Bulletin may be made to previous Victorian Government Gazettes, and to previous Victorian Law. In such cases, these references are deemed to be made to the corresponding sections of this Notice, and to the Heavy Vehicle National Law.

2.      Authorising Provision

 

This Notice is made under section 117 of the Heavy Vehicle National Law (HVNL).

 

3.      Title

 

This Notice may be cited as the Victoria Class 3 Livestock Carrier Mass and Dimension Exemption Notice 2019.

 

4.      Commencement

 

This notice commences on 10 February 2019.

 

5.      Expiry

 

This notice expires on 9 February 2024.

 

6.      Application

 

This notice applies to eligible vehicles operating in Victoria.

7.      Interpretation – s 748 Savings Provisions with regard to the Bulletin

This Notice works with, and refers to, the Bulletin. Certain references in the Bulletin may be made to previous Victorian Government Gazettes, and to Victorian Law. In such cases, for the purpose of this Notice these references are made to the corresponding sections of this Notice, and to the Heavy Vehicle National Law as per the savings provisions in s748 of the Heavy Vehicle National Law.

Note: This provision is intended to allow the Bulletin to function until all references to previous Victorian legislation and instruments are updated.

8.      Definition

 

(1)   Unless otherwise stated, words and expressions used in this notice have the same meanings as those defined in the HVNL.

 

(2)   In this Notice:

Eligible vehicle means a vehicle specified in s9 of this Notice.

 

General Access means access to all roads in Victoria, subject to the Victoria road rules and the heavy Vehicle National Law (HVNL).

 

Loading space means the length available for the carriage of livestock on a trailer as measured from the inside of the front wall or door of the trailer to the inside of the rear wall or door of the trailer, with any intervening partitions disregarded.

Note: the definition of ‘loading space’ is the definition for the length available for carrying livestock set out in s4(8) of Schedule 6 of the MDL Regulation.

Livestock means livestock as specified in the Scheme.

 

Livestock carrier means a heavy vehicle that is a heavy vehicle or combination that is higher than 4.3m but not higher than 4.6m and is built to carry livestock.

 

Bulletin means the Victoria Information Bulletin on Livestock Transport published and administered by VicRoads, as amended from time to time.

 

Scheme certificate means a certificate showing vehicle ratings, tare weight and semi-trailer loading space issued under the Scheme.

 

 

 

9.      Eligible Vehicles

 

(1)   An eligible vehicle is a heavy vehicle that:

a)      is a semi-trailer not more than 19m, or a nine axle B-double not more than 26m; and

b)      is equipped with Road Friendly Suspension;

c)      is equipped with dual tyres on all non-steering axles; and

d)      is a livestock carrier.

(2)   An eligible semi-trailer must have a tri-axle.

(3)   An eligible B-double must have a tri-axle on each B-double trailer.

 

10.  Exemption – Mass

 

(1)   Eligible vehicles operating under this Notice are exempt from the following mass requirements in Schedule 1 of the Heavy Vehicle (Mass, Dimension & Loading) National Regulation (MDL Regulation):

a)      section 2(1)(a)(iv) and 2(b);

b)      section 4 and Table 1 (Axle mass limits table); and

c)      section 5(1) and Table 2 (Axle spacing mass limits general table).

 

Note: Eligible vehicles and their components (including axles and tyres) are not exempt from exceeding manufacturer’s ratings and limits, including Gross Vehicle Mass (GVM), Gross Combination Mass (GCM) and Gross Trailer Mass (GTM).

11.  Exemption – Dimension

 

(1)   Eligible vehicles operating under this Notice are exempt from the following dimension requirements in Schedule 6 of the MDL Regulation:

 

a)      Section 4(6) to 4(8) - Loading space for livestock

b)      section 8 Height

 

Note: The exemption for loading space is required because the dimension requirements in s4(6) and (7) in Schedule 6 of the MDL Regulation specify particular animals that may not cover the range of livestock allowed to be carried under this Notice. The concessional dimensions re-instated in this Notice are the same as those in the MDL Regulation.

 

 

 

 

12.  Conditions – Stated Areas and Routes

(1)   An eligible vehicle operating under this Notice has road network access depending on the vehicle configuration and networks set out below:

 

a)      Prime-mover and semi-trailer combinations:- general access

b)      B-Doubles:- on Gazetted roads for B-Doubles as per the Victoria Gazetted B-Double Networks.

 

Note: the B-Double network mentioned above is published on the VicRoads website.

13.  Conditions – Mass limits (Prime Movers)

 

(1)   The tare weight of a prime mover with fuel must not exceed 11 tonnes.

(2)   The prime mover must have manufacturers’ ratings of at least:

a)      steer axle -  6.0 tonnes;

b)      drive axle group - 17.3 tonnes;

c)      GVM - 23.3 tonnes;

d)      GCM (single articulated) - 46.3 tonnes; and

e)      GCM (B-double) - 68.0 tonnes.

 

14.  Conditions – Mass Limits (Semi-Trailers)

 

(1)   The tare weight of a semi-trailer must not exceed 12 tonnes.

(2)   The total tare weight of the prime mover and semi-trailer must not exceed 22.0 tonnes.

Note: this is less than the sum of the allowable tare weights of the prime mover and the semi-trailer.

(3)   The semi-trailer must have a manufacturer’s rating of least 25.0 tonnes.

 

15.  Conditions – Mass (B-Doubles)

 

(1)   The total tare weight of the two trailers in a B-double combination must not exceed 21.0 tonnes.

(2)   The total tare weight of the combination must not exceed 32.0 tonnes.

 

16.  Condition – Height

 

(1)   An eligible vehicle operating under this notice must not exceed 4.6m in height by construction.

 

17.  Condition – Dimension (Loading Space)

 

(1)   The maximum loading space for livestock carriers is:

a)      12.5 metres for semi-trailers; and

b)      a total of 18.8 metres for B-double trailers.

 

18.  Condition – Axle Spacing

 

(1)                for prime mover and semi-trailer combinations:

  1. 4.0 metres between the centre of the steering axle to the centre of the rear axle of the prime mover; and
  2. 6.2 metres from the centre of the rear axle of the prime mover to the centre of the first axle of the semi-trailer.

 

(2)                for B-doubles, the axle and axle group spacings as specified in Table 3 in

Schedule 1 of the MDL Regulation.

 

19.  Condition - Carriage of Livestock

 

(1)   Deck level arrangements on any trailer operating under this Notice must comply with the Scheme requirements for a given animal.

 

(2)   An eligible vehicle must not carry livestock in any upper deck unless the lower deck of the vehicle is fully loaded with livestock.

 

(3)   An eligible vehicle must not carry any freight other than livestock.

 

20.  Conditions – Carriage of Fuel and Water

 

(1)   Fuel tanks must not be fitted to a semi-trailer operating under this Notice.

 

(2)   Any water carried on the semi-trailer must be in quantities for personal use only.

 

 

 

 

 

 

 

 

 

21.  Conditions- Victoria Information Bulletin on Livestock Transport

 

(1)   An eligible combination operating under this notice must be registered in and comply with all of the requirements of the Victoria Information Bulletin on Livestock Transport, including but not limited to:

 

a)      Eligible livestock; or

b)      Driver accreditation; or

c)      Vehicle certification.

 

Peter Caprioli

Executive Director (Freight and Supply Chain Productivity)

National Heavy Vehicle Regulator

 

Overview

The Victoria Class 3 Livestock Carrier Mass and Dimension Exemption Notice 2019, commenced on 10 February 2019, is designed to provide specific mass and dimension exemptions to support the Victorian livestock loading scheme. This Notice is enacted under section 117 of the Heavy Vehicle National Law (HVNL) and is intended to operate in conjunction with the Information Bulletin for the Livestock Transport (Victoria) issued by VicRoads. The Notice exempts eligible vehicles from certain mass and dimension requirements stipulated in the Heavy Vehicle (Mass, Dimension & Loading) National Regulation (MDL Regulation), provided these vehicles adhere to specific conditions regarding their configuration, mass limits, and dimensions. This Notice aims to facilitate the efficient transport of livestock within Victoria by allowing certain flexibility in vehicle specifications while ensuring compliance with overall safety and operational standards. The Notice applies to eligible vehicles operating in Victoria, which are defined as semi-trailers not exceeding 19 metres or nine-axle B-doubles not exceeding 26 metres, equipped with Road Friendly Suspension, dual tyres on non-steering axles, and built to carry livestock. It exempts these vehicles from specific mass and dimension requirements but imposes certain conditions, including restrictions on vehicle height, loading space, and carriage of livestock, fuel, and water. The Notice also specifies that the eligible vehicles must comply with the requirements set out in the Victoria Information Bulletin on Livestock Transport, including aspects like eligible livestock, driver accreditation, and vehicle certification.

Scope and Application

The Heavy Vehicle National Law Victoria Class 3 Livestock Carrier Mass and Dimension Exemption Notice 2019 (No.1) applies to eligible vehicles operating within Victoria. This Notice provides mass and dimension exemptions to support the Victorian livestock loading scheme, specifically targeting semi-trailers and B-doubles designed to carry livestock. The Notice is designed to work in conjunction with the Information Bulletin for the Livestock Transport (Victoria) issued by VicRoads. Vehicles eligible for these exemptions must adhere to specific criteria, including being a livestock carrier, having a certain configuration, and being equipped with specific suspension and tyre types. The exemptions cover certain mass and dimension requirements stipulated in the Heavy Vehicle (Mass, Dimension & Loading) National Regulation, such as axle mass limits and loading space dimensions, but vehicles are not exempt from exceeding manufacturer’s ratings. Conditions include restrictions on the vehicle's height, loading space, and axle spacing, and requirements for vehicle registration and compliance with the Victoria Information Bulletin on Livestock Transport. The Notice provides general access for eligible vehicles but restricts B-doubles to gazetted roads, as specified by VicRoads.

Key Provisions

The main operative sections of the Victoria Class 3 Livestock Carrier Mass and Dimension Exemption Notice 2019 (No.1) pertain to the exemptions and conditions applied to eligible vehicles in Victoria that transport livestock. Section 10 provides exemptions from certain mass requirements as outlined in Schedule 1 of the Heavy Vehicle (Mass, Dimension & Loading) National Regulation, such as axle mass limits and axle spacing mass limits. Section 11 exempts eligible vehicles from specific dimension requirements in Schedule 6 of the MDL Regulation, particularly those relating to the loading space for livestock and the height of the vehicle. The Notice also outlines the eligibility criteria for vehicles in Section 9, specifying the types of vehicles that qualify for these exemptions, such as semi-trailers and B-doubles, and the conditions they must meet, including equipment specifications and maximum dimensions. The obligations imposed by the Notice on the parties it governs are primarily concerned with compliance and adherence to specific conditions to maintain the integrity of the exemptions provided. Eligible vehicles must comply with the conditions set out in the Notice, including restrictions on mass limits, dimension requirements, and carriage of livestock, fuel, and water. The Notice mandates that eligible vehicles must be equipped with Road Friendly Suspension, dual tyres on all non-steering axles, and must adhere to the manufacturer's ratings and limits. Additionally, vehicles must comply with all requirements of the Victoria Information Bulletin on Livestock Transport, including registration, driver accreditation, and vehicle certification. Violations of the provisions outlined in the Notice can lead to various civil and criminal consequences. While the Notice does not explicitly list penalties, breaches of the Heavy Vehicle National Law or related regulations can result in significant fines and potential criminal charges. For instance, exceeding the specified mass and dimension limits without the appropriate exemptions could result in penalties under the Heavy Vehicle National Law, which can include substantial fines. Furthermore, operating a vehicle that does not comply with the conditions for eligibility or the requirements of the Victoria Information Bulletin could lead to enforcement actions, including vehicle impoundment and prosecution. The exact penalties would depend on the nature and severity of the breach, as well as the applicable provisions of the Heavy Vehicle National Law.

Legal classification tags

Area of Law
Administrative Law
Environmental Law
Instrument
Notice
Concepts
Definitions & Interpretation
Commencement Provisions
Licensing & Registration
Reporting & Disclosure Obligations
Compliance Obligations

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.