Airworthiness Directives 2004
I, DAVID ALAN VILLIERS, delegate of the Civil Aviation Safety
Authority, acting under subregulation 39.001 (1) of the Civil
Aviation Safety Regulations 1998:
(a) revoke the Airworthiness Directives mentioned in
Schedule 1; and
(b) make, as separate instruments, each Airworthiness
Directive mentioned in Schedule 1 and attached.
David Villiers
Delegate of the Civil Aviation Safety Authority
20 December 2004
Note: Each attached Airworthiness Directive is being re-made in exactly the
same form as appears in the latest published edition of the Directive.
Schedule 1 Revocation and Remaking of
Airworthiness Directives
Pilatus Britten Norman BN2A Mk III (Trislander) Series Aeroplanes
AD Name AD Number
Rudder Trim Jack Lower Mounting Bracket - Inspection and Modification AD/BNT/1
Aileron Mass Balance Attachment - Inspection and Modification AD/BNT/2
Flap Drive Pick Up Bracket AD/BNT/3 Amdt 1
Rudder Bar Assembly - Modification AD/BNT/4 Amdt 2
Flap Hinge Attachments - Inspection and Modification AD/BNT/5
Engine Mounting Frames - Inspection AD/BNT/6 Amdt 1
Pilots Seats Locking Mechanism - Inspection and Modification AD/BNT/7
Woodward Propeller Governor Drive Shaft - Inspection and Replacement AD/BNT/8
Elevator Trim Tab Cables - Replacement AD/BNT/9
Elevator Torque Tube - Inspection and Rework AD/BNT/10
Wing Bottom Surface Lamination Sta. 112 - Modification AD/BNT/11 Amdt 1
Rear Fuselage Undersurface - Modification AD/BNT/12
CANCELLED AD/BNT/13 Amdt 2
Hartzell Propeller Blades Installed on Centre Engine - Removal AD/BNT/14
Undercarriage Lower Bracket and Attachment - Engine Nacelle Area - AD/BNT/15 Amdt 2
Rudder Bar Lower Mounting - Inspection and Modification AD/BNT/16
Airframe Structural Fatigue Life Limitations AD/BNT/17 Amdt 2
Engine Mounting Brackets - Inspection AD/BNT/18
Passenger Seats - Inspection and Modification AD/BNT/19
Main Undercarriage Leg Outer Casing - Inspection AD/BNT/20
Flight Compartment Seat Back - Inspection and Modification AD/BNT/21
Aileron Mass Balance Tube - Inspection AD/BNT/22
Propeller Governors - Inspection and Adjustment - CANCELLED AD/BNT/23 Amdt 1
Rudder Stop Structure - Inspection and Modification AD/BNT/24
Elevator and Flap Control Rods - Inspection AD/BNT/25 Amdt 1
Engine Fire Warning - Modification AD/BNT/26
Rudder Mass Balance Arm Support Brackets - Inspection AD/BNT/27
Main Undercarriage Leg Tube - Inspection and Modification AD/BNT/28
Tailplane Attachment Bracket and Rear Pod Structure - Inspection AD/BNT/29
CANCELLED AD/BNT/30
Engine Controls Attachment Brackets - Modification AD/BNT/31
Undercarriage Shock Absorber Support Ring - Inspection and Rectification AD/BNT/32
Engine Control Shaft - Inspection AD/BNT/33
Wing Mounted Engine Upper Mounting Brackets AD/BNT/34 Amdt 2
Wing/Fuselage Attachment Pins - Inspection AD/BNT/35
Wing Tip Tank Fuel Contents Transmitter Floats - Inspection AD/BNT/36
Primary Structure Corrosion AD/BNT/37 Amdt 2
Pilots Switch Panel AD/BNT/38
Nose Wheel Steering Drive Ring - CANCELLED AD/BNT/39
Main Landing Gear Torque Link AD/BNT/40
Generator Inspection AD/BNT/41
Wing Spar Cap AD/BNT/42
NLG Leg Cylinder Bearing Surfaces AD/BNT/43
Nose Wheel Steering Drive-Ring AD/BNT/44 Amdt 1
Control Column Sliding Tube AD/BNT/45 Amdt 1
Throttle Friction Adjuster AD/BNT/46 Amdt 1
Main Landing Gear Oleo Attachment Bracket AD/BNT/47 Amdt 4
Emergency Exit Window AD/BNT/48
Engine Mounting Brackets AD/BNT/49 Amdt 1
Rear Engine Mounting Frame NB-51-H-1021 AD/BNT/50
Left and Right Rudder Bar Pillar and Slider Tube Assemblies AD/BNT/51
Control Column Universal Joint AD/BNT/52
Access Panel Bolts AD/BNT/53 Amdt 1
FHL Landing Gear Units AD/BNT/54
Folding Passenger Seat Rear Frame AD/BNT/55
Control Cable Swivel Unit Mounting Bracket AD/BNT/56