Airworthiness Directives 2004
I, DAVID ALAN VILLIERS, delegate of the Civil Aviation Safety
Authority, acting under subregulation 39.001 (1) of the Civil
Aviation Safety Regulations 1998:
(a) revoke the Airworthiness Directives mentioned in
Schedule 1; and
(b) make, as separate instruments, each Airworthiness
Directive mentioned in Schedule 1 and attached.
David Villiers
Delegate of the Civil Aviation Safety Authority
20 December 2004
Note: Each attached Airworthiness Directive is being re-made in exactly the
same form as appears in the latest published edition of the Directive.
Schedule 1 Revocation and Remaking of
Airworthiness Directives
Bombardier (Canadair) CL-600 (Challenger) Series Aeroplanes
AD Name AD Number
Windshield and Side Windows Reinforcing T Plates - CANCELLED AD/CL-600/1
Elevator Inboard Hinge Fitting - Inspection and Replacement AD/CL-600/2
Passenger Door Interior and Exterior Handles and Latch Mechanism - AD/CL-600/3
Auxiliary Power Unit Load Control Valve - Special Check and Adjustment AD/CL-600/4
Main Landing Gear Brake Assemblies - Inspection and Re-Identification AD/CL-600/5
Branson Fuel Tank - Electrical Harness - Inspection and Modification AD/CL-600/6
Horizontal Stabiliser Pitch Trim Actuator - Modification AD/CL-600/7
Landing Gear Electrical Harnesses - Modification AD/CL-600/8
Junction Box No.2 - Vertical Navigation and Glide Slope Relay - Modification AD/CL-600/9
Autopilot Duplex Servo - Installation of Protective Cover AD/CL-600/10
Stick Pusher - Inspection and Modification AD/CL-600/11
Throttle Quadrant Wear Strips - Special Check and Modification - CANCELLED AD/CL-600/12
Brake Control Push-Pull Cable AD/CL-600/13 Amdt 1
Engine Pylon Fuel Feed Tube Assembly - Modification AD/CL-600/14
Aileron and Elevator Flutter Dampers AD/CL-600/15 Amdt 1
Wing Outboard Flap Vane and Structure - CANCELLED AD/CL-600/16 Amdt 1
Flight Controls - Elevator Cable Inspection AD/CL-600/17
Introduction of Earthing Point AD/CL-600/18
Fire Extinguishing Bottle Squib Wiring AD/CL-600/19
ADG Output Harness Chafing AD/CL-600/20
Tail Cone Fuel Tank AD/CL-600/21 Amdt 2
Engine Fire Detection, Indication and Extinguishing Systems AD/CL-600/22
Brakes AD/CL-600/23 Amdt 1
Generator and APU Feeder Wires AD/CL-600/24
Throttle Quadrant AD/CL-600/25 Amdt 1
Flap Actuators AD/CL-600/26
Rudder Control Quadrant AD/CL-600/27 Amdt 1
Sunstrand Air Driven Generator AD/CL-600/28
Horizontal Stabiliser Trim Actuator AD/CL-600/29
Time Limits and Maintenance Checks AD/CL-600/30
Fuel Tank Arcing Prevention AD/CL-600/31
Underfloor Pressure Bulkhead at FS409.00 AD/CL-600/32 Amdt 2
Overwing Emergency Exit Hatches AD/CL-600/33
Flap Operation AD/CL-600/34 Amdt 2
Main Landing Gear Main Fitting AD/CL-600/35 Amdt 1
Elevator Flutter Damper Shear Pins AD/CL-600/36
Flight Spoiler Centre Hinge Fitting AD/CL-600/37 Amdt 1
IDG Cables and Firewall Separator AD/CL-600/38 Amdt 1
Fuel Level Sensing Wiring Chafing AD/CL-600/39
Electrical Power - Chafing of IDG Cables AD/CL-600/40
Fire Warning Control Unit AD/CL-600/41
Lower Wing Plank AD/CL-600/42
Cargo Compartment Smoke Detector AD/CL-600/43
Power Transfer Contactors AD/CL-600/44
Engine Support Beam AD/CL-600/45
Main Windshield Fasteners AD/CL-600/46
Center Tank Fuel Transfer Shutoff Valve AD/CL-600/47
CVR/FDR Paint Stripping AD/CL-600/48
Angle of Attack Transducer AD/CL-600/49
Main Fuel Tank Vent System Modification AD/CL-600/50
Chafed IDG Cables AD/CL-600/51
Refuel Floodlight AD/CL-600/52
Fuel Migration and Centre of Gravity Limit AD/CL-600/53
CL-600-2B19 RJ Overwing Exit Placards AD/CL-600/54
Flap Vane System AD/CL-600/55
APU Cooling Air Exhaust AD/CL-600/56
Horizontal Stabilizer Trim Actuator AD/CL-600/57
Aileron Stiffness AD/CL-600/58
IDG Cables AD/CL-600/59
Flap Vane Brackets AD/CL-600/60
Main Landing Gear Side-Brace Fitting Shaft AD/CL-600/61