AD/HS 125/154 Amdt 1 - Engine Pylon Firewall

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B10435 In force Legislative Instrument

Legislation content

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 



British Aerospace BAe 125 Series Aeroplanes

 

AIRWORTHINESS DIRECTIVE


For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/HS 125/154 and issues the following AD under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

 

AD/HS 125/154

Amdt 1


Engine Pylon Firewall 7/2000

 

Applicability: Model BAe 125-800A and BAe 125-800B, Model Hawker 800, and Model Hawker 800XP series aircraft; as listed in Raytheon Service Bulletin SB.54-1-3815B, Revision 1, dated May 1998.

 

Requirement: Fill all unused tooling holes in the left and right engine pylon firewalls with firewall sealant, in accordance with Raytheon Service Bulletin SB.54-1-3815B, Revision 1.

 

Note: FAA AD 2000-08-07 Amdt 39-11693 refers.

 

Compliance: Before 13 January 2001, unless already accomplished. This Amendment becomes effective on 13 July 2000.

Background: Reports were received of aircraft with two unused (open) tooling holes on the left hand and right hand engine pylon firewalls which may permit an engine fire moving to the fuselage, and to the lines that carry flammable fluid that are located inboard of the firewall.

 

Amendment 1 is issued in response to a new FAA AD which requires further action due to reports of additional unused tooling holes, found at locations other than those previously addressed.

 

The original issue of this Airworthiness Directive became effective on 15 August 1996.


 

Bernard Malcolm Hole

Delegate of the Civil Aviation Safety Authority 2 June 2000

 

 

 


The above AD is notified in the Commonwealth of Australia Gazette on 14 June 2000.

 

 

 

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.