AD/GAF-N22/75 Amdt 1 - Horizontal Stabiliser Access Panel Intercostal Angles and Upper and Lower Skins

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B10225 In force Legislative Instrument

Legislation content

COMMONWEALTH OF AUSTRALIA (Civil Aviation Safety Regulations 1998), 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 


AIRWORTHINESS DIRECTIVE


For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/GAF N22/75 and issues the following AD under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

 

GAF N22 and N24 Series Aeroplanes

 

AD/GAF-N22/75

Amdt 1


Horizontal Stabiliser Access Panel Intercostal Angles and Upper and Lower Skins


10/2001

 

 

Applicability: Model N22 and N24 aircraft with line sequence numbers listed in the Requirement document.

Requirement: Inspect in accordance with ASTA Nomad Service Bulletin NMD-55-34 Revision 1. Compliance:               At the next 100 hour inspection after 18 July 1996 or before 12 September 1996,

whichever occurs first. Thereafter at intervals not to exceed 100 hours time in service or 12 calendar months, whichever occurs first.

 

The compliance times of the original issue of this Directive remain unchanged by this issue.

 

This amendment becomes effective on 4 October 2001.

 

Background: Reports were received by the manufacturer of cracking of the horizontal stabiliser upper and lower skin, at the ends of the horizontal stabiliser access hole intercostal angles and in the horizontal stabiliser trailing edge channel.

 

Amendment 1 introduces a revision of the Requirement document, which was issued to provide for replacing rivets with screws in the access panels and to clarify figures.

 

The original issue of this Airworthiness Directive became effective on 18 July 1996.


David Alan Villiers

Delegate of the Civil Aviation Safety Authority 22 August 2001

 

 

 

 


The above AD is notified in the Commonwealth of Australia Gazette on 12 September 2001.

 

 


Page 1 of 1

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.