AD/ECUREUIL/85 - Exhaust Duct and Fuel Line Interefence

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B09389 In force Legislative Instrument

Legislation content

 

 


AIRWORTHINESS DIRECTIVE

For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.


 

Eurocopter AS 350 (Ecureuil) Series Helicopters

 

AD/ECUREUIL/85 Exhaust Duct and Fuel Line Interference 7/2003

TX

 

Applicability: AS 350 B3 helicopters equipped with the optional engine flushing system and modified per MOD 073098, and EC 130 B4 helicopters equipped with the optional engine flushing system.

Requirement: 1. Check the condition of the fuel transfer line, the condition of the air exhaust duct, and the clearances in the interference area in accordance with paragraph 2.B.1 of Eurocopter AS 350 Alert Service Bulletin (ASB) No. 71.00.16 or Eurocopter EC 130 ASB 71A001 as applicable.

 

2.        If wear marks are found:

 

  1. Carry out the maintenance procedure detailed in the Engine Maintenance Manual Task 70-40-02-200-001-A01 if the wear is less than or equal to 0.05mm.
  2. Replace the fuel line if the deepest wear mark is more than 0.05mm but less than 0.2mm.
  3. Replace the fuel line if the deepest wear mark is more than 0.2mm

 

3.        Replace any air exhaust duct found perforated.

 

4.        Reposition the air exhaust duct where there is insufficient clearance between the duct and the fuel transfer line in accordance with paragraph 2.B.2 of the referenced ASB.

Note: DGAC AD’s 2003-208(A) and 2003-209(A) refer.

 

Compliance:

1.

 

2.

For Requirement 1; Within 10 flight hours from the effective date of this Directive.

a. For Requirement 2a; Before further flight.

 

2.

b. For Requirement 2b; Within 50 flight hours or 1 month from the effective date of this Directive, whichever occurs first.

 

2.

c. For Requirement 2c; Before further flight.

Eurocopter AS 350 (Ecureuil) Series Helicopters

 

AD/ECUREUIL/85 (continued)

 

3.        For Requirement 3; Before performing any engine flushing operations.

 

4.        For Requirement 4; Whenever any work is performed on the bleed valve exhaust duct and whenever a duct is installed.

 

This Airworthiness Directive becomes effective on 30 May 2003.

 

Background: This Directive is in response to a fuel transfer line found damaged as a result of rubbing due to vibration with the bleed valve exhaust duct.


Jim Coyne

Delegate of the Civil Aviation Safety Authority 28 May 2003

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


The above AD is notified in the Commonwealth of Australia Gazette on 30 May 2003.

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.