COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY
SCHEDULE OF AIRWORTHINESS DIRECTIVES
Douglas DC4 Series Aeroplanes
AD/DC4/28 Fire Protection Modifications NK
Applicability: All models.
Requirement: 1. Modify the aeroplane to provide a level of protection against fire in flight equivalent to that called for in Section 101.1.3.1 of Air Navigation Orders.
2. Incorporation of all Douglas SBs listed in para. 3 of this Order together with the incorporation of the modifications detailed in para. 4 of this Order constitutes an acceptable means of meeting the above requirements.
3. DC4 Service Bulletins:
No. Title
47 Install Firewall-Cabin Forward Bulkhead, Ceiling Panels and Reworkable Floor Panel.
49 Oil Cooler Fairing and Inner Ring Seal.
55 Replace Micarta Fairleads for Engine Controls through Nacelle Firewall and Inner Ring.
61 Replacement of Generator Current Control Relay.
64 Installation of Cabin and Nose Heater Fire Extinguisher and Fuel System.
65 Firewall Junction Box Steel Cover Plate attached to Firewall.
66 Fire Prevention - Engine Section. Piping and Fitting Revision.
Note: This Bulletin calls for the replacement of existing electrical disconnect plugs on the fire- wall by stainless steel plugs. It will be sufficient for the purpose of this Order if only that component of the plug actually attached to the firewall be made of fire-proof material.
67 Addition of Fire Extinguisher Lines Aft of Firewall and CO2 Bottles in Nose Wheel Well.
68 Installation of “Y” Outlet Stiffener Flange on Exhaust Collector Rings.
70 Installation - Generator Blast Tube Shut-off System.
85 Revision of Engine Section Surface De-icer Pressure Line-Vacuum Pump to Separator.
In addition to the requirements of para. 3 of this Order, modify aeroplanes as follows:-
COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY
SCHEDULE OF AIRWORTHINESS DIRECTIVES
4.1. Fit fireproof seals around the cowl flap jack shafts where they pass through the fire seal baffles.
4.2. Seal with fireproof material all holes and gaps in the fire seal baffles.
4.3. Seal with fireproof material the gaps around the engine integral oil sump lines at the bottom of the fire seal baffles.
4.4. Seal with fireproof material the gaps between the bottom of the fire seal baffles and inner diaphragms in the area of the engine integral sump lines.
4.5. Using fireproof material, seal the fire seal baffles around the engine crankcase bosses, including the two bosses used for magneto vent line passage.
4.6. Fit fireproof seals over holes in inner diaphragm cup shrouds around the pre- heat controls.
4.7. Provide shut-off means in propeller feathering lines in those installations which utilise the combination starter and feathering pump unit.
4.8. Install an approved fire detector system in Zone 1.
4.9. Install an approved fire detector system in Zone 2 and approved fire detectors aft of the firewall in nacelle Zone 3. OR
2. ANO 105.1.16.2.5.27, Issue 2.