AIRWORTHINESS DIRECTIVE
For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.
Cessna 206 Series Aeroplanes
AD/CESSNA 206/55 Horizontal Stabiliser Attachment
Brackets - 2
7/2002
Applicability: | Model | Serial Numbers |
| P206C and TP206C | P206-0420 through P206-0519 |
| P206D and TP206D | P206-0520 through P206-0603 |
| P206E and TP206E | P20600604 through P20600647, and P206-0001 |
| U206C and TU206C | U206-0915 through U206-1234 |
| U206D and TU206D | U206-1235 through U206-1444, U20601445 through |
|
| U20601587 |
| U206E and TU206E | U20601588 through 20601700 |
| U206F and TU206F | U20601701 through U20602588, U20602590 through U20603521 |
| U206G and TU206G | 676, U20602589, U20603522 through U20607020 |
Requirement: 1. Check the maintenance records, and determine whether a horizontal stabiliser attachment reinforcement bracket (bracket) part number (P/N) 1232624-1 is installed that was shipped by Cessna from 27 February 1998 through 17 March 2000. If the installed brackets were not shipped by Cessna between 27 February 1998 and 17 March 2000, no further action is required by this Directive.
2. If the above check reveals that affected P/N 1232624-1 brackets are installed, visually inspect the left and right brackets for existence of seam welds along both the lower inboard and outboard wall/flange.
3. If no seam weld is found on the left or right bracket during the Requirement 2 inspection, before further flight, replace with a new or serviceable P/N 1232624- 1 bracket. If the left and right brackets have seam welds along both the lower inboard and outboard wall/flange, no further action is required.
Note: FAA AD 2002-07-01 Amdt 39-12695 refers.
Cessna 206 Series Aeroplanes
AD/CESSNA 206/55 (Continued)
Compliance: Within 50 hours time in service after 11 July 2002, unless already accomplished.
This Airworthiness Directive becomes effective on 11 July 2002.
Background: The FAA received a report that certain horizontal stabiliser attachment reinforcement brackets were manufactured without seam welds. This Directive specifies actions to detect and replace structurally deficient attachment brackets. Continued use of such brackets could result in structural failure of the horizontal stabiliser.
David Ala n Villiers
Delegate of the Civil Aviation Safety Authority 28 May 2002
The above AD is notified in the Commonwealth of Australia Gazette on 19 June 2002.