AD/CESSNA 150/45 - STOL Conversion Wing Stall Fence

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B04943 In force Legislative Instrument

Legislation content

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 


Cessna 150, F150, 152 & F152 Series Aeroplanes

 

AD/CESSNA 150/45 STOL Conversion Wing Stall Fence 10/96

Applicability: Any model fitted with "Bush Conversions Inc." Short Take Off and Landing (STOL) kit installed in accordance with FAA STC SA1371SW.

 

Requirement: Measure the height of the wing stall fence at the trailing edge. If the height exceeds

32.5 mm (1.28 inches) install a smaller fence in accordance with a scheme approved pursuant to CAR35 through a District Office of the Authority.

 

Note 1. FAA AD 96-12-23 refers.

 

Note 2. The diagram below is extracted from the FAA AD for guidance.


Compliance: Within 100 hours time in service after 12 September 1996.

 

Background: This Directive is issued to prevent modified aircraft from entering a stall condition due to excessive stall fence height, which could result in loss of control of the aircraft.

 

 

 

 

 

 

 

 

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.