AD/BN-2/77 Amdt 1 - Access Panel Bolts

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B04790 In force Legislative Instrument

Legislation content

COMMONWEALTH OF AUSTRALIA (Civil Aviation Safety Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 


AIRWORTHINESS DIRECTIVE


For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/BN-2/77 and issues the following AD under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.


 

Pilatus Britten-Norman BN-2 Series Aeroplanes

 

AD/BN-2/77

Amdt 1


Access Panel Bolts 11/2003

 

Applicability: All BN2, BN2A, BN2B, BN2T, BN2T-4R, and BN2T-4S series Islander aircraft. Requirement:              Inspect in accordance with action 6.1, 6.2, and 6.3 of B-N Group Mandatory Service

Bulletin SB 291, dated 1 May 2003.

 

An appropriate bolt approved by Type Certificate holder may replace the A113-1D bolts listed in Service Bulletin SB 291 dated 1 May 2003.

 

Compliance: For action 6.1: At the next daily check after 4 June 2003, unless already accomplished.

 

For action 6.2 and 6.3: At the latest by the next major maintenance inspection. This Amendment becomes effective on 30 October 2003.

Background: The manufacturer received a report of an aileron travel restriction due to incorrect length bolts installed in left and right access panels at W.STA 181.68, adjacent to the aileron bellcrank levers.

 

This amendment approves the use of alternative bolts approved by the Type Certificate holder to replace the A113-1D bolts listed in the Service Bulletin.

 

The original issue of this Airworthiness Directive became effective on 4 June 2003.


David Villiers

Delegate of the Civil Aviation Safety Authority 10 September 2003

 

 

 

 

 

The above AD is notified in the Commonwealth of Australia Gazette on 8 October 2003.

 

 


Page 1 of 1

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.