AD/BELL 47/69 Amdt 1 - Tail Rotor Control Pedal Assembly Interference Bracket

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B04697 In force Legislative Instrument

Legislation content

 

 


AIRWORTHINESS DIRECTIVE

On the effective date specified below, and for the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/BELL 47/69 and issues the following AD under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

 

Bell Helicopter Textron 47 (All Variants) Series Helicopters

 

AD/BELL 47/69

Amdt 1


Tail Rotor Control Pedal Assembly Interference Bracket


10/2004

 

Applicability: All model 47G series.

 

Requirement: 1. Verify interference (stop) brackets P/N 47-622-165-1 are correctly installed under pilot’s and co-pilot’s inboard footrest. (See figure 1).

 

2. Correctly install interference (stop) brackets P/N 47-622-165-1 where these brackets are not installed, or incorrectly installed.

 

Note: The bracket prevents fitment of incorrectly assembled dual control tail rotor pedals.


 

Figure 1

Bell Helicopter Textron 47 (All Variants) Series Helicopters

 

AD/BELL 47/69 Amdt 1 (continued)

 

Compliance: For requirement 1, unless previously accomplished, within 10 flight hours after the effective date of this Directive and thereafter, at intervals not to exceed 12 months.

 

For requirement 2, before further flight.

 

This Amendment becomes effective on 30 September 2004.

 

Background: This AD was initially issued in October 1971 in response to a fatal accident, which was attributed to incorrectly installed dual tail rotor control pedals. The installation of interference (stop) brackets would have facilitated the correct installation of dual controls.

 

Amendment 1 was issued in response to recent field reports of missing brackets, and incorrectly installed dual tail rotor control pedals.


Neville Probert

Delegate of the Civil Aviation Safety Authority 19 August 2004

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


The above AD is notified in the Commonwealth of Australia Gazette on 8 September 2004.

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.