AD/BELL 206/145 - Tail Rotor Blade Part Number 206-016-201

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B04460 In force Legislative Instrument

Legislation content

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 



Bell Helicopter Textron Canada (BHTC) 206 and Agusta Bell 206 Series Helicopters

 

AIRWORTHINESS DIRECTIVE


For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

 

AD/BELL 206/145 Tail Rotor Blade Part Number 206-016-201 10/2000

TX

Applicability: All Agusta-Bell AB206A and AB206B helicopters equipped with tail rotor blade part number 206-016-201 (all dash numbers) that have accumulated less than 25 flight hours.

 

All Bell Helicopter Textron Canada 206 series helicopters equipped with tail rotor blade part number 206-016-201 (all dash numbers) that were procured through Agusta SpA and have accumulated less than 25 flight hours.

 

Requirement: Action in accordance with Agusta Bollettino Technico 206-234, dated 10 August 2000.

 

Note: RAI AD 2000-394 refers.

 

Compliance: Before further flight after 18 August 2000 for Part I of the Requirement document, unless already accomplished. As specified in the Requirement document for the Part II requirement, if affected.

 

This Airworthiness Directive becomes effective on 18 August 2000.

 

Background:  Reports have been received of two cases of the loss of the central balance weight, installed at the tip of the affected tail rotor blades. This Directive requires certain actions, and a radiographic inspection if affected.


 

 

Steve Swift

Delegate of the Civil Aviation Safety Authority 18 August 2000

 

 


The above AD is notified in the Commonwealth of Australia Gazette on 18 August 2000.

 

 

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.