AD/BEECH 55/85 Amdt 1 - Aircraft Flight Manual, Flight into Icing Conditions

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B04031 In force Legislative Instrument

Legislation content

 



Beechcraft 55, 58 and 95-55 (Baron) Series Aeroplanes

 

AIRWORTHINESS DIRECTIVE


For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/BEECH 55/85 and issues the following AD under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

 

AD/BEECH 55/85

Amdt 1


Aircraft Flight Manual, Flight into Icing Conditions


7/2000

 

Applicability: Models E55, E55A, 58, 58A, 58P, 58PA, 58TC, and 58TCA. Requirement:  Revise:

  1. the Limitations Section of the aircraft's Aircraft Flight Manual (AFM) by incorporating the following:

 

"WARNING"

Severe icing may result from environmental conditions outside of those for which the aircraft is certificated.

 

Flight in freezing rain, freezing drizzle, or mixed icing conditions (super cooled liquid water and ice crystals) may result in:

 

  • ice build-up on protected surfaces and exceed the capability of the ice protection system, or

 

  • ice forming aft of the protected surfaces.

This ice may not be shed using the ice protection systems, and may seriously degrade the performance and controllability of the aircraft.

 

During flight, severe icing conditions that exceed those for which the aircraft is certificated shall be determined by the visual cues described below. If one or more of these visual cues exists, immediately request priority handling from Air Traffic Control to facilitate a route or an altitude change to exit the icing conditions. The cues are:

 

  • unusually extensive ice accumulation on the airframe and windscreen in areas not normally observed to collect ice, and/or

 

  • accumulation of ice on the upper surface of the wing aft of the protected area, and/or

 

  • accumulation of ice on the engine nacelles and propeller spinners farther aft than normally observed.

Since the auto-pilot, when installed and operating, may mask tactile cues that indicate adverse changes in handling characteristics, use of the auto-pilot is prohibited when any of the visual cues specified above exist, or when unusual lateral trim requirements or auto-pilot trim warnings are encountered while the aircraft is in icing conditions.

 

All wing icing inspection lights must be operative prior to flight into known or forecast icing conditions at night. This direction supersedes any relief provided  by any Minimum Equipment List.

 

2.     the Normal Procedures Section of the AFM by incorporating the following:

 

THE FOLLOWING WEATHER CONDITIONS MAY BE CONDUCIVE TO SEVERE IN-FLIGHT ICING:

  • Visible rain at temperatures below 0 degrees Celsius ambient air temperature;
  • Droplets that splash or splatter on impact at temperatures below 0 degrees Celsius ambient air temperature.

 

PROCEDURES FOR EXITING A SEVERE ICING

ENVIRONMENT: (These procedures are applicable to all flight phases from take-off to landing.)

 

Monitor the ambient air temperature.

 

While severe icing may form at temperatures as cold as -18 degrees Celsius, increased vigilance is warranted at temperatures around freezing when visible moisture is present.

 

 

If the visual cues which are specified in the Limitations Section of the AFM for identifying severe icing conditions are observed, accomplish the following:

 

  • Immediately request priority handling from Air Traffic Control to facilitate a route or an altitude change to exit the severe icing conditions in order to avoid extended exposure to flight conditions more severe than those for which the aircraft has been certificated.

 

  • Avoid abrupt and excessive manoeuvring that may exacerbate control difficulties.

 

  • Do not engage the autopilot.
  • If the autopilot had previously been engaged, hold the control wheel firmly and disengage the autopilot.

 

  • If an unusual roll response or un-commanded roll control movement is observed, reduce the angle-of-attack.

 

  • Do not extend flaps when holding in icing conditions. Operation with flaps extended can result in a reduced wing angle-of-attack, with the possibility of ice forming on the upper surface further aft on the wing than normal, possibly aft of the protected area.

 

  • If the flaps are extended, do not retract them until the airframe is clear of ice.
  • Report these weather conditions to Air Traffic Control.

Note 1: Certificate of Registration holders should initiate action to ensure notification of this change is conveyed to any person who may operate their aircraft as pilot in command.

 

Note 2: FAA AD98-04-24 refers.

 

Certification for accomplishment of this Directive may be carried out:

 

  1. after a copy of this Directive is included in the appropriate sections of the aircraft's AFM; and

 

b.    may be carried out at a minimum, by the holder of a private pilot's licence.

 

 

Compliance: Within 30 days after the effective date of this Amendment.

 

This Amendment becomes effective on 13 July 2000.

 

Background:  This Directive is issued to minimise the potential hazards associated with operating the aircraft in severe icing conditions by providing more clearly defined procedures and limitations associated with such conditions.

 

Amendment 1 is raised to correct a word processing error in the initial issue.

 

The original issue of this Airworthiness Directive became effective on 23 March 2000.


 

Bernard Malcolm Hole

Delegate of the Civil Aviation Safety Authority 31 May 2000

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


The above AD is notified in the Commonwealth of Australia Gazette on 14 June 2000.

Overview

The Civil Aviation Safety Authority (CASA) issued Airworthiness Directive AD/BEECH 55/85 Amdt 1 for the Beechcraft 55, 58 and 95-55 (Baron) Series Aeroplanes in July 2000. This Airworthiness Directive aims to mitigate the risks associated with operating these aircraft in severe icing conditions by providing more clearly defined procedures and limitations. It was enacted under subregulation 39.1 (1) of the Civil Aviation Regulations 1998, with the policy objective of enhancing aviation safety by ensuring that pilots are adequately informed and prepared to handle in-flight icing conditions that may exceed the aircraft’s certification limits. The directive mandates specific updates to the Aircraft Flight Manual, including revised warnings and procedures for flight into known or forecast icing conditions, to ensure that pilots can recognise and respond appropriately to severe icing situations. This measure is intended to prevent potential hazards that could arise from inadequate response to icing conditions, thereby safeguarding both the aircraft and its occupants.

Scope and Application

The Airworthiness Directive AD/BEECH 55/85 Amdt 1 applies to specific Beechcraft 55, 58 and 95-55 (Baron) Series Aeroplane models, including E55, E55A, 58, 58A, 58P, 58PA, 58TC, and 58TCA. The directive is issued under the authority of the Civil Aviation Safety Authority (CASA) to address potential hazards associated with operating these aircraft in severe icing conditions. It mandates that the limitations and normal procedures sections of the Aircraft Flight Manual (AFM) be revised to incorporate specific warnings and procedures for identifying and exiting severe icing conditions. Compliance with these requirements must be achieved within 30 days from the effective date of the amendment, which is 13 July 2000. The directive applies to the aircraft irrespective of the location of operation within Australia, as it is issued by the Commonwealth authority CASA. The directive does not specify any exclusions, exemptions, or thresholds, and its application is not extended or restricted through subordinate instruments.

Key Provisions

The key operative sections of the Airworthiness Directive (AD) AD/BEECH 55/85 Amendment 1 involve specific revisions to the Aircraft Flight Manual (AFM) for the Beechcraft 55, 58, and 95-55 (Baron) series aeroplanes. Section 1 mandates the incorporation of a new warning and limitations into the AFM (section 1(a)), detailing the risks and cues of severe icing conditions (section 1(b)). Section 2 requires the inclusion of normal procedures and weather conditions conducive to severe in-flight icing, along with procedures for exiting such conditions (section 2(a) and 2(b)). The AD applies to specific models of the Beechcraft aeroplanes (section Applicability). The compliance period is set within 30 days from the effective date of the Amendment, which is 13 July 2000 (section Compliance). The obligations imposed by this AD require the Certificate of Registration holders to ensure that the AFM is updated with the new information specified in the AD. This includes adding the new warning and limitations regarding severe icing conditions and the revised procedures for handling such conditions. Certificate holders must ensure that any person who may operate their aircraft as pilot in command is notified of these changes (section Requirement). The AD also mandates that the AFM be updated within a specified timeframe, and certification of compliance can be performed by a holder of a private pilot’s licence. The AD outlines potential consequences for non-compliance. While specific penalties are not detailed in the text, failure to comply with the AD could result in the aircraft being deemed unairworthy. This could lead to enforcement actions by the Civil Aviation Safety Authority (CASA), potentially including fines or other regulatory penalties. The seriousness of the potential hazards associated with operating the aircraft in severe icing conditions underscores the importance of adhering to the AD to ensure safety. The AD establishes clear requirements and procedures to mitigate the risks of operating under severe icing conditions. By incorporating the specified warnings, limitations, and procedures into the AFM, the AD aims to enhance flight safety. Certificate holders are obligated to update their AFMs accordingly and ensure that all relevant personnel are informed of the changes. Failure to comply with these requirements could result in regulatory consequences, highlighting the importance of adherence to the AD.

Legal classification tags

Instrument
Legislative Instrument
Concepts
Definitions & Interpretation
Reporting & Disclosure Obligations
Enforcement Powers
Catchwords
Aircraft Flight Manual

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.