AD/B767/175 - Thrust Reverser Wiring

Administered by Department of Infrastructure, Transport, Regional Development, Communications, Sport and the Arts

Legislation au F2006B03350 In force Legislative Instrument

Legislation content

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 


AIRWORTHINESS DIRECTIVE


For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

 

Boeing 767 Series Aeroplanes

 

AD/B767/175 Thrust Reverser Wiring 9/2002

 

Applicability: Model 767-300 series aeroplanes, line numbers 001 through 810 inclusive, equipped with Rolls Royce RB211-524H series engines.

 

Requirement:  1. Re-route wire bundle W518 (which is located along the leading edge of the right wing from the outboard pressure seal to the wing/strut disconnect), according to Boeing Service Bulletin (SB) 767-78-0085, dated 8 November 2001.

2. Perform the functional test specified in SB 767-78-0085.

 

Note: FAA AD 2002-14-02 Amdt 39-12802 refers.

 

Compliance: For Requirement 1 - Within 36 months after the effective date of this Directive.

 

For Requirement 2 - Before the next flight, after completing Requirement 1 re-routing of wire bundle W518.

This Airworthiness Directive becomes effective on 5 September 2002.

 

Background: This Directive requires re-routing wire bundle W518 containing control wiring for the thrust reverser actuation system. This action is necessary to ensure that control

wiring for the thrust reverser actuation system is adequately separated. Inadequately separated wiring could allow a single failure to result in uncommanded deployment of a thrust reverser and consequent reduced controllability of the airplane.


 

Eugene Paul Holzapfel

Delegate of the Civil Aviation Safety Authority 29 July 2002

 

 

 

 

 

 

 

 

 

The above AD is notified in the Commonwealth of Australia Gazette on 14 August 2002.

 

 


Page 1 of 1

Interactions

Authorises

All Versions

Sourced from the Federal Register of Legislation at 26 August 2026. For the latest information on Australian Government law please go to https://www.legislation.gov.au.